Fuel consumption display, adapting

Rapid data transfer HELP
Select function XX

Indicated on display:

Adaptation
Enter channel number XX

Indicated on display:

NOTE:

Adaptation is only possible on vehicles with on-board computer.
The value entered must be between 85% and 115%.
The value must be entered in steps of 5%.
If the value "100" was changed due to a customer complaint, the changed value must be entered into a new instrument cluster.

Channel 3 Adaptation 100 →
< - 1 3- >

Indicated on display:

NOTE: The fuel consumption display can only be adapted via direct input.

Channel 3 Adaptation 100
Enter adaptation value XXXXX

Indicated on display:

Enter required adaptation value via button pad on scan tool, filling in the initial spaces with "0."

Example:

Channel 3 Adaptation 100 Q
Enter adaptation value 00090

Indicated on display (example only):

Channel 3 Adaptation 90 Q
Store changed value?

Indicated on display:

Channel 3 Adaptation 90 →
Changed value is stored

Indicated on display:

Rapid data transfer HELP
Select function XX

Indicated on display:

NOTE: If an incorrect entry is made the testing unit will switch to function mode.

Function is unknown or →
cannot be carried out at the moment

Indicated on display:

Press " button.
Select adaptation function (function 10) and adaptation channel 03 again.
Repeat adaptation of fuel consumption display and confirm entry with -Q- button.