Diagnostic Trouble Code (DTC) Memory, checking (function 02)

NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.

Initiate On Board Diagnostic (OBD) of immobilizer. Refer to Anti-theft immobilizer On Board Diagnostic (OBD), initiating .

Fig 1: Diagnostic System VAS 5051: Display -- Basic Setting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS 5051/5052:

Fig 2: Identifying Content Of DTC Memory & Identification Of Fault On Diagnostic System VAS 5051 Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS 5051/5052:

1 - DTC memory content:

[small diamond] 0 malfunctions recognized

[small diamond] X malfunctions recognized

2 - Diagnostic Trouble Code (DTC)

[small diamond] DTC

[small diamond] malfunction location

[small diamond] malfunction type

If malfunctions were recognized:

Refer to Operating instructions for the VAS 5051/5052 tester

Fig 3: Diagnostic System VAS 5051: Display -- Basic Setting

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS 5051/5052:

Repair malfunction(s) according to DTC table. Refer to DTC table .
In selection -1-, press diagnostic function "02 - Check DTC Memory" again and Erase DTC Memory. Refer to Diagnostic Trouble Code (DTC) Memory, erasing (function 05)
In selection, click on diagnostic function "06 - End Output". Refer to End Output (function 06) .

If no malfunction was recognized:

In selection -1-, click on diagnostic function "06 - End Output". Refer to End Output (function 06) .