Adaptation of fuel gauge sender resistance range
This function is used to adjust the resistance range for the fuel gauge sender in order to compensate for any misalignment of the fuel gauge sender.
Indicated on display
- Press -1- and -0- and confirm by pressing the -Q- button.
Indicated on display
- Press -Q- button to confirm input
Indicated on display:
- Press buttons 3- and -0-.
- Press -Q- button to confirm input.
Indicated on display (example only): Adaptation value is indicated, here, for example 128.
NOTE:
- "128" is the adaptation value for the standard resistance range for the fuel gauge sender as set by the factory.
- The resistance value for the fuel gauge sender resistance range can be adjusted by +/- 8 Ohm to give an adaptation value between 120 and 136.
- If the value "128" was changed due to a customer complaint, the changed value must be transferred when replacing instrument cluster.
- Press --> button.
Indicated on display (example only):
- Input desired correction value via scan tool keypad, fill initial positions with "0."
Example:
Desired input value: 132
Keypad input: 00132
Indicated on display (example only):
- Press -Q- button to confirm input.
Indicated on display (example only):
- Press -Q- button to confirm input.
Indicated on display (example only):
- Press -Q- button to confirm input.
Indicated on display (example only):
- End adaptation of the fuel gauge sender resistance range by pressing the --> button.