Example 3

Using the DTCs stored in the memories, you have determined that none of the control modules are sending or receiving signals.

Fig 1: Example 3 DTCs Stored In Memory - None Of The Control Modules Are Sending Or Receiving Signals

Courtesy of AUDI OF AMERICA, INC.

• Switch ignition off.
• Disconnect the control modules connected across the bus lines and check the bus lines for an open circuit.

  See appropriate System Wiring Diagram article.

Fig 2: Schematic - Control Modules Connected Across Bus Lines
Courtesy of AUDI OF AMERICA, INC.

• Check the bus lines for short circuit to B+ or Ground (GND).
Fig 3: Schematic - Checking Bus Lines For Short Circuit
Courtesy of AUDI OF AMERICA, INC.