LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2003 >> S8 >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> On Board Diagnostic (OBD) >> Anti-theft immobilizer, On Board Diagnostic >> Emergency start function using VAG 1551 >> Requirements

Emergency start function using VAG 1551: Requirements

After control module identification is displayed:

Indicated on display

Fig 1: V.A.G 1551 Scan Tool Display - Emergency Start Function (1 Of 4)
G02729486Courtesy of AUDI OF AMERICA, INC.

Indicated on display

Fig 2: V.A.G 1551 Scan Tool Display - Emergency Start Function (2 Of 4)
G02729487Courtesy of AUDI OF AMERICA, INC.

Indicated on display

Fig 3: V.A.G 1551 Scan Tool Display - Emergency Start Function (3 Of 4)
G02729488Courtesy of AUDI OF AMERICA, INC.

Indicated on display

Fig 4: V.A.G 1551 Scan Tool Display - Emergency Start Function (4 Of 4)
G02729489Courtesy of AUDI OF AMERICA, INC.
NOTE: Once the emergency start procedure has been successfully completed, the warning lamp will light constantly and the immobilizer will be switched free:
NOTE:
  • After three incorrect entries of the secret number, the immobilizer is locked.
  • It is not possible to make another attempt for 10 minutes. During this time, the ignition must remain constantly switched on. This time is doubled after every third consecutive incorrect attempt, up to a maximum of 255 minutes.
  • If no buttons or knobs are operated for more than 30 seconds during the input procedure, the emergency start attempt is aborted.
  • If emergency start attempt is performed successfully, vehicle can be started within 45 minutes with the S-contact closed
  • With S-contact open, i.e. vehicle key removed, engine can only be started within 5 minutes.