Test requirements
- Fuse OK per wiring diagram
See appropriate System Wiring Diagram article.
- VAG1551 Scan Tool (ST) connected. See VAS 5051 TESTER OR VAG 1551/1552 SCAN TOOL (ST), CONNECTING .
- Switch ignition on.
NOTE:
- If the display remains blank, check the voltage supply of the VAG1551 Scan Tool (ST) according to the wiring diagram.
- Additional operating instructions can printed out by pressing the HELP button.
- The --> button is used to advance through the program sequence.
- If an incorrect entry is made, press the -C- button to escape.
- In "Rapid data transfer" operating mode 1 the "Automatic Test Sequence" function 00 can be carried out. This checks DTC memory of all vehicle control modules (with OBD capability) automatically.
- Switch ignition on.
- Switch printer on by pressing PRINT button (indicator lamp in button lights up).
- Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display
Address word for radio: 56
- Press buttons -5- and -6- to enter "Radio" address word 56.
Indicated on display
- Press -Q- button to confirm input.
NOTE:
While the On Board Diagnostic (OBD) program is running "DIAG" will appear on the radio unit display.
Through m.y. 2001
Indicated on display after about 5 seconds (example only):
From m.y. 2002
Indicated on display after about 5 seconds (example only):
All vehicles
- 4B0035195A: Part No. for radio (Symphony)
- 8E0035195B: Part No. for radio (Symphony US)
- Radio: component designation
- symphony II NP2: component designation and manufacturer
- D00: software version installed in radio
- 0004: software version installed in radio
- Coding 00117: radio coding
- Coding 02637: radio coding
- WSC 06812: dealership number
NOTE:
Check/confirm coding using coding table. See CODING TABLE - THROUGH M.Y. 2001
.
- Press --> button.
- If display shows one of the following messages, carry out troubleshooting procedure as described in troubleshooting program for diagnostic wiring.
See appropriate System Wiring Diagram article.
Indicated on display
After the HELP button is pressed, a list of the possible functions is printed out.
- Press --> button to advance through program sequence.