Instrument cluster, removing and installing: Installing
Installation is reverse of removal, noting the following:
- Connect electrical harness connectors and affix wiring harness to rear of instrument cluster with cable ties.
- After installation, perform a function test of the instrument cluster.
- If the function test is OK, enter the input values for the instrument cluster (i.e.: SRI etc. where applicable):
- Code instrument cluster according to market and equipment versions using the VAS 5051 tester
- Adapt odometer reading to new/exchange instrument cluster using the VAS 5051 tester
- Adapt anti-theft immobilizer functions supported by the instrument cluster to Engine Control Module (ECM) using the VAS 5051 tester