Work procedure

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 Audi A6, 2003 Audi S6, 2003 Audi A6, 2002 Audi S6, and 2002 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: To reduce the risk of accident during road tests, always observe safety precautions. See SAFETY PRECAUTIONS .

Connect diagnostic tester. See CONNECT DIAGNOSTIC TESTER .
Start engine and let run at idle for at least 15 minutes.
Perform a 15 minute road test in the highest gear or in the highest driving mode on a level driving surface.
The following operating conditions must be met during this road test:
- Engine speed 1800 to 2200 RPM; "PID 12: Engine rotations per minute". See MODE 1: CHECK MEASURED VALUES .
- Vehicle speed constant 90 km/h; "PID 13: Vehicle speed". See MODE 1: CHECK MEASURED VALUES .
Read readiness code. See READ READINESS CODE .