Minimum mileage performance

This function is used to set a fixed minimum mileage performance in the instrument cluster for the SRI.

Indicated on display

Fig 1: V.A.G 1551 Scan Tool Display - Minimum Mileage Performance (1 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press -1- and -0- and confirm by pressing the -Q- button.

Indicated on display

Fig 2: V.A.G 1551 Scan Tool Display - Minimum Mileage Performance (2 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input.

Indicated on display:

Fig 3: V.A.G 1551 Scan Tool Display - Minimum Mileage Performance (3 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press buttons -4- and -2-.
Press -Q- button to confirm input.

Indicated on display (example only): Factory adjusted value for the minimum mileage performance (in miles) until next service is indicated (here for example 8 represents 8000 miles)

Fig 4: V.A.G 1551 Scan Tool Display - Minimum Mileage Performance (4 Of 9)

Courtesy of AUDI OF AMERICA, INC.

NOTE:

The currently valid specifications can be found in the "Maintenance" book.
Input of current specified value is only possible in units of 1000, indication in display also changes in 1000 units.
In countries where speedometers are calibrated in miles, adaptation can be performed in miles.
When replacing instrument cluster, this value is already adjusted.
It is only possible to input values via direct input using the keypad of the scan tool.
If incorrect value is input, the "Adaptation" function is terminated and must be re-initiated.