Rear lid lock cylinder, removing and installing
NOTE:
The following list refers to Fig 1.
- Housing
- For lock cylinder
- Clip
- Coupling piece
- Assembling. See ASSEMBLING .
- Torsion spring
- Installing. See ASSEMBLING .
- Follower
- Installing. See ASSEMBLING .
- Circlip
- Clip
- Ball (2x)
- Both balls must be greased before installing
- When installing, make sure that balls do not drop out of holes
- Guide cap
- Guide cap cannot be removed without being destroyed
- Roller (2x)
- Assembling. See ASSEMBLING .
- Lock cylinder
Removing:
- Remove cover of right-side light in rear lid.
- Press securing clip to side at operating rod for lock opening and for central locking actuator and remove operating rod.
- Loosen nuts at housing for lock cylinder.
- Pull housing for lock cylinder toward interior and out of light.
- Disassembling. See DISASSEMBLING .
- Key