Initiating output Diagnostic Test Mode

Indicated on display

Fig 1: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (1 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Press buttons -0- and -3- to select "output Diagnostic Test Mode" function 3.

Indicated on display:

Fig 2: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (2 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input: Output Diagnostic Test Mode for analog indicators is initiated immediately.

Indicated on display:

Fig 3: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (3 Of 10)

Courtesy of AUDI OF AMERICA, INC.

The following tests are performed simultaneously:

Sweep of coolant temperature needle through entire display range
Sweep of tachometer needle through entire display range
Sweep of speedometer needle through entire display range
Sweep of fuel gauge needle through entire display range

After sweep of display ranges, the following fixed values are displayed:

FIXED VALUES DISPLAY

Engine Coolant Temperature (ECT) gauge:	1/2
Tachometer:	3000 1/min
Speedometer:	62 MPH
Fuel gauge:	1/2

NOTE: Switching ignition on and off will abort any needle sweep that has been initiated.

Press --> button.

Indicated on display:

Fig 4: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (4 Of 10)

Courtesy of AUDI OF AMERICA, INC.

All lamps are switched on that are activated by the processor.

Press --> button.

Indicated on display:

Fig 5: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (5 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Seat belt warning light is activated.

NOTE: Depending on options/version, the seat belt warning light may be activated by the control module coding, i.e. if this actuator test is omitted, the warning light is not active.

Press --> button.

Indicated on display:

Fig 6: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (6 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Chime is activated and sounds the entire time.

Press --> button.

Indicated on display:

Fig 7: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (7 Of 10)

Courtesy of AUDI OF AMERICA, INC.

All display points of the driver information display, the LCD clock/date indicator and the LCD odometer are activated.

Press --> button.

Indicated on display:

Fig 8: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (8 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Instrument cluster illumination is automatically set twice to bright and dark and then switched to maximum illumination (bright).

Press --> button.

Indicated on display:

Fig 9: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (9 Of 10)

Courtesy of AUDI OF AMERICA, INC.

Press --> button to end output Diagnostic Test Mode.

The tester returns to the "Select function" mode.

Indicated on display

Fig 10: V.A.G 1551 Scan Tool Display - Initiating Output Diagnostic Test Mode, Instrument Cluster (10 Of 10)

Courtesy of AUDI OF AMERICA, INC.