Test requirements
- Fuse OK per wiring diagram
See SYSTEM WIRING DIAGRAMS .
- VAG 1551 or VAS 5051 Scan Tool (ST) connected. See VAS 5051 TESTER OR VAG 1551/1552 SCAN TOOL (ST), CONNECTING .
NOTE:
- If the display remains blank, check the voltage supply of the VAG1551 Scan Tool (ST) according to the wiring diagram.
- Additional operating instructions can printed out by pressing the HELP button.
- The --> button is used to advance through the program sequence.
- If an incorrect entry is made, press the -C- button to escape.
- In "Rapid data transfer" operating mode 1 the "Automatic Test Sequence" function 00 can be carried out. This checks DTC memory of all vehicle control modules (with OBD capability) automatically.
- Switch ignition on.
- Switch printer on by pressing PRINT button (indicator lamp in button lights up).
- Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display
Address word for Telematics: 75
- Press buttons -7- and -5- to enter "Telematics" address word 75.
NOTE:
- The title for address word 75 may appear in the VAG 1551/1552 or VAS 5051 tester as "Emergency call module".
- While the On Board Diagnostic (OBD) program is running, the emergency call function is deactivated.
- After display appears, press -Q- button to confirm input.
Indicated on display after about 5 seconds (example only):
- 8E0035616: Part No. for Telematics
- Telematik USA1: system description
- 0001: Telematics software version
- Coding 0002333: Telematics coding
- WSC XXXXX: dealership number
NOTE:
Check/confirm coding using coding table. See CODING TABLE:
.
- Press --> button.
- If display shows one of the following messages, carry out troubleshooting procedure as described in troubleshooting program for diagnostic wiring.
Courtesy of AUDI OF AMERICA, INC.
Courtesy of AUDI OF AMERICA, INC.
Courtesy of AUDI OF AMERICA, INC.
Indicated on display
After the HELP button is pressed, a list of the possible functions is printed out.
Press --> button to advance through program sequence.