Output DTM, initiating

Press buttons -0- and -3 to select "Output Diagnostic Test Mode (DTM)", function 03.

Indicated on display:

Fig 1: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (1 Of 6)

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input.

Indicated on display

Fig 2: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (2 Of 6)

Courtesy of AUDI OF AMERICA, INC.

The hands-free speaker is briefly supplied with current (not audible).

NOTE: The malfunction type "short circuit of wires to each other" for the hands-free speaker can only be detected via the output Diagnostic Test Mode (DTM). If this malfunction occurs, it is stored in DTC memory (00851).

Press --> button.

Indicated on display

Fig 3: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (3 Of 6)

Courtesy of AUDI OF AMERICA, INC.

A tone is emitted from the loudspeaker for approx. three seconds.

Press --> button.

Indicated on display

Fig 4: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (4 Of 6)

Courtesy of AUDI OF AMERICA, INC.

The following test pattern appears in the instrument cluster display:

Fig 5: Identifying Instrument Cluster Display

Courtesy of AUDI OF AMERICA, INC.

The test pattern appears in the complete display range.

The display changes in 4 second interval between normal and inverse illustration.

Press --> button.

Indicated on display

Fig 6: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (5 Of 6)

Courtesy of AUDI OF AMERICA, INC.

Press --> button.
The tester returns to the "Select function" mode.

Indicated on display

Fig 7: Identifying Scan Tool Display - Output Diagnostic Test Mode, Navigation System III (6 Of 6)

Courtesy of AUDI OF AMERICA, INC.