Test requirements
- Check fuses according to wiring diagram
- Always check coding of instrument cluster according to code table. See CODING TABLE: .
- Connect VAS 5051 tester or VAG 1551 scan tool. See VAS 5051 TESTER OR VAG 1551 SCAN TOOL, CONNECTING AND SELECTING FUNCTIONS .
- Switch on ignition
NOTE:
- If nothing is indicated on display, check voltage supply for VAG 1551 scan tool according to wiring diagram.
- Additional instructions can be called up via the HELP button on the scan tool.
- The --> button is used for advancing through the program sequence.
- An incorrect entry can be canceled using the -C- button.
- Function 00 "Automatic test sequence" can be performed in operating mode 1 "Rapid data transfer." This automatically checks all control modules installed in the vehicle.
- Switch on ignition
- Switch printer on via the PRINT button (indicator lamp in button lights up).
- Press button -1- to select "Rapid data transfer" operating mode 1.
Indicated on display
Address word: 17
- Press buttons -1- and -7-.
Indicated on display:
- Press -Q- button to confirm input.
Indicated on display (example only): after approx. 5 seconds:
- 4D0919035AD: Part number of instrument cluster
- D2-INSTRUMENT CLUSTER: component marking
- VDO: Manufacturer's code
- D19: Software version of instrument cluster
- Coding 02283: Coding of instrument cluster
- WSC 06812: dealership number
NOTE:
Check coding according to code table. See Coding table:
.
- Press --> button.
Indicated on display (example only):
- WAUZZZ4DZYN000126: 17 digit VIN (Vehicle Identification Number)
- AUZ7Z0W0801181: 14 digit identification number of control module for anti-theft immobilizer
- Press --> button.
If one of these messages is displayed, perform trouble shooting according to troubleshooting diagnostic.
Indicated on display
- Pressing the HELP button will print out an overview of all of the possible functions.