LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2002 >> allroad Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (On Board Diagnostic (OBD) - 4.2L V8 5V - BBD) >> On Board Diagnostic (OBD) >> Readiness code >> Readiness code, generating >> Operation 8: Diagnosis, oxygen sensor control system

Operation 8: Diagnosis, oxygen sensor control system

WARNING: This page is about a different car, the 2003 Audi S6 and 2002 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Indicated on display

Fig 1: VAG 1551 Scan Tool Display - Diagnosis, Oxygen Sensor Control System (1 Of 2)
G03613754Courtesy of AUDI OF AMERICA, INC.

Display readout

Fig 2: VAG 1551 Scan Tool Display - Diagnosis, Oxygen Sensor Control System (2 Of 2)
G03613755Courtesy of AUDI OF AMERICA, INC.
DISPLAY GROUP 037: OXYGEN SENSOR CONTROL SYSTEM (BANK 1)

  Display zones
1 2 3 4
Display group 037: Oxygen sensor control system (bank 1) 
Display  xx.x % x.xxx V xxx ms Test ON 
Display  Load Voltage of oxygen sensor behind catalytic converter, bank 1 Oxygen correction value between oxygen sensor 1 and oxygen sensor 2, Bank 1 Diagnosis status
Range  0...175 % 0.000...1.000 volts --- Test OFF 
Test ON 
Syst. OK 
Syst. NOK 
Specified value  14...24 % 0.000...1.000 volts -800ms...800ms Syst. OK 
Note:        If "syst. NOK" is displayed check DTC memory  . See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING AND ERASING .

If specified value in display zone 4 "Syst OK" is attained:

DISPLAY GROUP 038: OXYGEN SENSOR CONTROL SYSTEM (BANK 2)

  Display zones
1 2 3 4
Display group 038: Oxygen sensor control system (bank 2) 
Display  xx.x % x.xxx V xxx ms Test ON 
Display  Load Voltage of oxygen sensor behind catalytic converter, bank 2 Oxygen correction value between oxygen sensor 2 and oxygen sensor 2, Bank 1 Diagnosis status 
Range  0...175 % 0.000...1.000 volts --- Test OFF 
Test ON 
Syst. OK 
Syst. NOK 
Specified value  14...24 % 0.000...1.000 volts -800ms...800ms Syst. OK 
Note:        If "syst. NOK" is displayed check DTC memory  . See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING AND ERASING .

If the specified value in display zone 4 "Syst OK" is attained: