Coolant pump, removing and installing: Installing
Install in the opposite order to removing. When installing, note the following points:
- Remove residues of sealant on sealing surfaces of coolant pump and cylinder block.
- Clean sealing surfaces; ensure that they are free of oil grease.
- Install new gasket on coolant pump flange.
- Insert coolant pump into cylinder block and tighten all 9 securing bolts -2-.
- Secure rear toothed belt guard at coolant pump housing -1-.
- Tightening torque: 10 Nm.
- Install toothed belt. See TOOTHED BELT, REMOVING AND INSTALLING .
- Install ribbed belt. See RIBBED BELT, REMOVING AND INSTALLING .
- Install toothed belt guard.
- Fill cooling system. See COOLING SYSTEM, DRAINING AND FILLING .