Lock cylinder, removing and installing: Installing

Installation is reverse of removal, noting the following:

• Insert spare key into lock cylinder and turn to position "ignition on".
• Re-insert steel wire or pin -1- into the hole in front of lock up to stop.
• Slide lock cylinder -2- with ignition key into steering column housing.
Fig 1: Using Steel Wire Or Pin To Install Lock Cylinder With Ignition Key Into Steering Column Housing
Courtesy of AUDI OF AMERICA, INC.
• Then pull out wire and press in lock cylinder firmly until catch engages audibly.
• Connect electrical connection at induction coil for anti-theft immobilizer.