Headlights, removing and installing: Installing

Installation is reverse of removal, noting the following:

• Adjust dimension -a- via plastic bolt at new headlight.
  NOTE: Determine dimension -a- at plastic bolt of old headlight, when being replaced.
Fig 1: Measuring Distance At Plastic Bolt Of Old Headlight
Courtesy of AUDI OF AMERICA, INC.
• Engage headlight in area of center of vehicle in guide -2- via pin -1-.
Fig 2: Engaging Headlight In Area Of Center Of Vehicle In Guide Via Pin
Courtesy of AUDI OF AMERICA, INC.
• Always align headlight according to contours of chassis (gap dimensions) and secure.
• Adjust headlight after installing. See HEADLIGHTS, ADJUSTING  .