Oil seal for left Camshaft Position (CMP) sensor, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2004 Audi A6, 2003 Audi S6, 2003 Audi A6, 2002 Audi S6, and 2002 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

Clean contact and sealing surfaces.
NOTE: Do not apply oil to sealing lip or outer circumference of seal before installing.
Install guide sleeve (from tool set 3241) onto camshaft.
Press in seal until flush using press sleeve 3241/1 and bolt 3241/3.
Install Camshaft Position (CMP) sensor rotor.

Fig 1: Installing Oil Seal For Left Camshaft Position (CMP) Sensor Seal Using Press Sleeve 3241/1 And Bolt 3241/3
Courtesy of AUDI OF AMERICA, INC.
Install CMP sensor housing.
Connect connector for CMP sensor.

Tightening torques

TIGHTENING TORQUES: CMP SENSOR HOUSING

Component	Nm/ft lb
CMP sensor housing	10/7
CMP sensor rotor	23/17

Unplug connector from CMP sensor.