Rear bumper, removing, installing and assembly overview
NOTE:
The following list refers to items in Fig 1.
- Bolt w/washer assembly
- 23 Nm (17 ft lb)
- Impact absorber
- Removing and installing, see IMPACT ABSORBER, REMOVING AND INSTALLING
- Cross member
- Bumper cover removed
- Remove bolt w/washer assembly and remove cross member from long member.
- Bumper cover removed
- Lower back panel trim
- To remove, remove self-tapping Phillips-head screws -5- (6x)
- Self-tapping Phillips-head screw
- 1.5 Nm (13 in. lb)
- Bumper cover
Removing:
- Unscrew flanged nuts -10- (accessible through luggage compartment).
- Luggage compartment trim must be partially disassembled
- Remove flanged nuts -11- (accessible through trunk under tail light).
- Guide
- Removing and installing, see GUIDE, REMOVING AND INSTALLING
- Screw w/washer assembly
- 1 Nm (9 in. lb)
- Wheelhousing liner
- Flanged nut (2x)
- 6 Nm (53 in. lb)
- Flanged nut (2x)
- 6 Nm (53 in. lb)
- Seal