Left rear level control system sensor -G76-, removing and installing: Removing

The level sensor is secured at the left rear control arm and bolted to a retaining plate with two hex nuts -4- at the subframe.
Disconnect connector.
To remove sensor from retaining plate and linkage, remove hex nut -3- and both socket head bolts -2- (3mm) at level sensor -1-.

Fig 1: Removing Sensor From Retaining Plate And Linkage (Left Rear)

Courtesy of AUDI OF AMERICA, INC.

Fig 2: Removing Sensor From Retaining Plate And Linkage (Left Rear)

Courtesy of AUDI OF AMERICA, INC.