Tire pressure monitoring system, setting up

It is necessary to set up the tire pressure monitoring system again if the control module has been changed or if malfunction "01487" has occurred.

• First check whether the instrument cluster is correctly configured and encoded.

  A "1" must be entered in display box 1 of measured value block 130.

  See ON BOARD DIAGNOSTIC (OBD) - UP TO 2000 or ON BOARD DIAGNOSTIC (OBD) - 2001 AND UP .

If there is no entry:

• Configure the instrument cluster accordingly

  See ON BOARD DIAGNOSTIC (OBD) - UP TO 2000 or ON BOARD DIAGNOSTIC (OBD) - 2001 AND UP .

• Switch the ignition off and on again once only.
• Encode the control module for tire pressure monitoring. See CODE CONTROL MODULE (FUNCTION 07)  .
• Check DTC memory and then erase it. See CHECK DTC MEMORY (FUNCTION 02)  .

  All wheels must have the correct tire pressures.

• If necessary, inflate the tires to the correct pressure.
• Now proceed in accordance with the instructions in the "Set up" menu; store the tire pressure in the "Store pressures" box and confirm the menu item.
• Switch the ignition off and on again once only.
• No malfunctions must have been recorded in the DTC memory of the instrument cluster and the tire pressure monitoring system control module.

If any malfunctions have been recorded, repair them first.

• Carry out a test drive (not less than 20 minutes).
• Switch the ignition off and on again once only.
• The reading "Wheel fl" should now appear in display box 1 of measured value block 001.