Erase DTC Memory (function 05) and End Output (function 06)

Preconditions: 

• DTC memory has been checked

1. Erase DTC Memory 
   • Press the --> button

   Display: (Clearance for function selection)

   Fig 1: VAG 1551 Scan Tool - Select Function XX

   Courtesy of AUDI OF AMERICA, INC.
   • Press the -0- and -5- buttons; 05 causes entry of the "Erase DTC Memory" function.

   Display:

   • Confirm entry using the Q button
     Fig 2: VAG 1551 Scan Tool - 05 - Erase DTC Memory

     Courtesy of AUDI OF AMERICA, INC.

   Display:

   Fig 3: VAG 1551 Scan Tool - DTC Memory Has Been Cleared

   Courtesy of AUDI OF AMERICA, INC.
   • Press the --> button

   Display: (Clearance for function selection)

   Fig 4: VAG 1551 Scan Tool - Select XX Function

   Courtesy of AUDI OF AMERICA, INC.
   NOTE:

   • If this display appears, the test sequence is incorrect.
   • Adhere precisely to the test sequence: First check the DTC memory, then clear it.
   Fig 5: VAG 1551 Scan Tool - DTC Memory Hasn't Been Checked

   Courtesy of AUDI OF AMERICA, INC.
2. End Output 

   Display:

   Fig 6: VAG 1551 Scan Tool - Select XX Function

   Courtesy of AUDI OF AMERICA, INC.
   • Press the -0- and -6- buttons; this ends output.

   Display:

   Fig 7: VAG 1551 Scan Tool - 06 - End Output

   Courtesy of AUDI OF AMERICA, INC.
   • Confirm entry using Q button

   Display:

   Fig 8: VAG 1551 Scan Tool - Enter Address Word XX

   Courtesy of AUDI OF AMERICA, INC.
   • Switch ignition off
   • Disconnect link to VAG1551 scan tool