Output Diagnostic Test Mode (function 03): Notes
NOTE:
- Output Diagnostic Test Mode can be performed only with the vehicle stationary and the engine switched off.
- If a malfunction is indicated during Output Diagnostic Test Mode, find the cause of the malfunction and eliminate it!
- Switch the ignition on.
The following final control elements are activated one after the other during the final control test:
- Check control system for normal level and indicator light
- Check the LED's in the operating unit
- Check the release valve and the valve at left front
- Check the release valve and the valve at right front
- Check the compressor and the compressor relay
- Release valve and valve at left rear
- Release valve and valve at right rear
- Pressure accumulator test
- Test result