On Board Diagnostic (OBD) functions

The following functions are possible:

1. 01- Check Control Module Versions. See CHECK CONTROL MODULE VERSIONS (FUNCTION 01)  .
2. 02- Check DTC Memory. See DTC TABLE, FOUR-WHEEL SELF LEVELING SUSPENSION SYSTEM  .
3. 03- Output Diagnostic Test Mode. See OUTPUT DIAGNOSTIC TEST MODE (FUNCTION 03)  .
4. 04- Start basic setting. See BASIC SETTING (FUNCTION 04)  .
5. 05- Erase DTC Memory. See ERASE DTC MEMORY (FUNCTION 05) AND END OUTPUT (FUNCTION 06)  .
6. 06- End Output. See ERASE DTC MEMORY (FUNCTION 05) AND END OUTPUT (FUNCTION 06)  .
7. 07- Code Control Module. See CODE CONTROL MODULE (FUNCTION 07)  .
8. 08- Read Measuring Value Block. See READ MEASURING VALUE BLOCK (FUNCTION 08)  .
9. 10- Adaptation. See ADAPTATION (FUNCTION 10), ACTIVATING AND DEACTIVATING SELF LEVELING SUSPENSION SYSTEM  .
10. 11- Login-Procedure. See BASIC SETTING (FUNCTION 04)  .