LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2002 >> S6 4.2 L >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (On Board Diagnostic (OBD) - 4.2L V8 5V - Art, Awn) >> On Board Diagnostic (OBD) >> Output Diagnostic Test Mode (DTM) >> Output DTM for engine code: ART >> Notes

Output DTM for engine code: ART: Notes

WARNING: This page is about a different car, the 2004 Audi A6, 2003 Audi A6, 2002 Audi A6, 2001 Audi A6, and 2000 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The DTM can only be performed with the ignition switched on and the engine not running.
  • The DTM is terminated if the engine is started or if an engine speed pulse is detected.
  • During the DTM, individual control elements will be activated for approx. 1 minute, or until the test program is advanced to the next control element by pressing the --> button.
  • The control elements can be tested either by listening or by touching.
  • The electric fuel pump runs continuously throughout the DTM.
  • If the DTM is to be repeated, the engine must be started. The engine control module needs to detect an engine speed of more than 300 rpm.
scientia non olet · About LEMON Manuals