Exhaust Malfunction Indicator Light (MIL), significance: Notes

WARNING: This page is about a different car, the 2004 Audi A6, 2003 Audi A6, 2002 Audi A6, 2001 Audi A6, and 2000 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.

If the Engine Control Module (ECM) recognizes emission related malfunctions, this is indicates by the MIL coming on.

Component location of MIL

Fig 1: Identifying Exhaust Malfunction Indicator Light

Courtesy of AUDI OF AMERICA, INC.

NOTE: When a recognized malfunction switches on the MIL, it will either blink or light continuously. In either case, the DTC memory must be checked. See DIAGNOSTIC TROUBLE CODE (DTC) MEMORY, CHECKING AND ERASING .

Blinking MIL

If the MIL starts to blink, there is a malfunction that can lead to damage of the Three Way Catalytic Converter (TWC). In this case driving should be only continue with reduced power until the MIL goes out or stays on continuously. The malfunction must be corrected as soon as possible.

Continuous MIL

If the MIL lights continuously, there is malfunction that affects exhaust emissions. In this case the DTC memory of the ECM and TCM must be checked and the malfunction must be corrected as soon as possible.
Some malfunctions may occur without causing the MIL to come on. When driveability or performance problems are reported and there is no indication from the MIL, the operation of the MIL must be checked. In addition, the DTC memory of the ECM and TCM must be checked, as there may be malfunctions stored that do not switch the MIL on immediately.