Left connector station, removing and installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Location: Left connector station - arrow - is located in left footwell beneath A-pillar trim.
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Remove A-pillar trim: → 70 - INTERIOR TRIM .
- Press retaining clip and detach connector point from A-pillar - arrow -.
- Unclip fuse panel at connector point.
- Remove relays or control modules and then unclip appropriate relay carrier.
NOTE:
- Refer to the applicable wiring diagram for exact identification of connections on connector station Wiring Diagrams.
Installing
Install in reverse order of removal, noting the following:
- Install A-pillar trim: → 70 - INTERIOR TRIM .