Trunk Lock/Alarm/Central Locking Switch F124 - Sedan through 10.04, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove rear lid lock → 55 HOOD, LIDS .

Fig 1: Identifying Catch, Retaining Bolts, And Contact Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Use flat screwdriver to pry plastic tab - 3 - from retaining pins - 1 -.
Fold plastic tab completely to rear.
First pull contact switch - 2 - to one side and then upwards out of lock for rear lid.

Installing

Install in reverse order of removal, noting the following:

NOTE:

Ensure washers are properly positioned between plastic tab and lock for rear lid.
Install rear lid lock → 55 HOOD, LIDS .