Headlamp washer spray jets, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Remove front bumper cover → 63 BUMPER .

NOTE:

To protect the bumper cover, place a cloth under pliers before taking hold of the spray jet.

Fig 1: Pulling Cover Of Spray Jet Upwards Away From Bumper Cover And Carefully Disengaging Retainers

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Pull cover - 1 - of spray jet - 2 - upwards away from bumper cover and carefully disengage retainers in direction of - arrow -.

Fig 2: Identifying Hose, Spray Jet, And Screws

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release clamp and remove hose - 1 - at spray jet - 2 -.
Remove screws - arrows - and detach spray jet.

Installing

Install in reverse order of removal, noting the following:

Install front bumper cover → 63 BUMPER .

Tightening torque

Component - fastener	Nm
Spray jet to bumper cover - screw	3