Pressing in flange shaft
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Before pressing in flange shaft, tighten damper.
NOTE:
- If a sealing ring is installed with additional dust lip Differentiation of sealing rings , a flange shaft must be installed with a groove → As of serial number 42987 - Flange shaft with nut and sealing ring with additional dust lip
- Install securing ring.