Selector shaft with selector cylinder, removing and installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Multi-purpose tool VW 771/1
- Puller T40050
Removing
- Remove bolts - arrows - and remove selector shaft cover - B -.
Fig 4: Pulling Out Both Selector Shaft Locking Bushes Using Multi-Purpose Tool VW 771/1 And Puller T40050
- Pull out both selector shaft locking bushes (- item A - in Fig 3) using multi-purpose tool VW 771/1 and puller T40050.
- Make sure that no gear has been engaged.
- Push selector shaft - A - into transmission as far as it will go, simultaneously removing pin - B -.
- Pull out selector shaft.
Installing
Installation is performed in reverse sequence; note the following:
- Push assembly sleeve 01E 311 120 - A - onto selector shaft - B -.
- Install complete selector shaft.
- Installation position: Chamfer of selector shaft points downwards.
- Push selector shaft - A - into transmission as far as it will go, simultaneously inserting pin - B -.
- Installation position of pin - B - : lug on pin points in direction of transmission housing.
- Fit cover - B - and tighten bolts - arrows -.
- Drive in selector shaft locking bushes onto stop.
Tightening torque
| Component | Nm |
|---|---|
| Selector shaft cover to transmission | 24 |