Installing flange shaft oil seal (left-side)

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Driving In New Flange Shaft Oil Seal Using Driver 2062

GW00019062

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Lightly oil outer circumference of new seal.
Drive in new flange shaft oil seal using driver 2062; keep seal straight when installing.

Insertion depth: 5.50 ± 0.15 mm below top of cover.
Pack space between sealing lip and dust lip half-full with sealing grease G052128A1 .

Drive flange shaft in with needle bearing drift VW295.