Fog lights, removing and installing

Removing 

• Switch ignition off and remove ignition key.
• Turn light switch into -0- position.

Fig 1: Releasing Catches Using Screwdriver And Removing Air Intake Grille On Left/Right On Bottom Part Of Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disengage catches -1- to -4- using a screwdriver -arrow- and pull off air inlet grid in lower part of bumper.

Fig 2: Identifying Bolts For Headlight Insert

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts -arrows-.
• Remove headlight insert.
• Unplug connector.

Installing 

Installation is reverse of removal, paying attention to the following:

• Adjusting fog lights. Refer to Fog light, adjusting .

Tightening torque