Battery, disconnecting and connecting
Procedure
See Caution before beginning repairs on the electrical system. Refer to Battery, removing and installing
- Note and if necessary, determine radio code for vehicles equipped with coded anti-theft radio / radio navigation system only foreign brands).
- Switch ignition off.
- Slide cover over the battery to the right -arrow 1- and pull it off upwards -arrow 2-.
- Disconnect Ground (GND) strap at battery -arrow-.
- To connect, connect terminal clamp of Ground (GND) cable by hand to battery negative post"-" and tighten nut.
NOTE:
- Be sure to activate vehicle features (radio/radio-navigation system, clock, electric window regulators) according to owner's manual when the battery is reconnected.
- Deactivate service mode of Telematic Control Module.
Refer to 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER
- Further measures after reconnecting power supply:
Refer to
- 24 MULTIPORT FUEL INJECTION (MFI) for 1.8 LITER 4-CYL. 5V TURBO FUEL INJECTION & IGNITION, ENGINE CODE(S): AMB
- 24 - MULTIPORT FUEL INJECTION (MFI) for 2.0 LITER 4-CYL. 4V TURBO FUEL INJECTION IGNITION, ENGINE CODE(S): BPG, BWT
- 24 MULTIPORT FUEL INJECTION (MFI) for 3.0 LITER 6-CYL. 5V FUEL INJECTION & IGNITION, ENGINE CODE(S): AVK, BGN
- 24 - FUEL INJECTION SYSTEM for 3.2 V6 4V FUEL INJECTION IGNITION, ENGINE CODE(S): BKH
- 24 - MULTIPORT FUEL INJECTION (MFI) for 4.2 LITER V8 4V FUEL INJECTION AND IGNITION, ENGINE CODE(S): BNS
- 24 MULTIPORT FUEL INJECTION (MFI) for 4.2 LITER V8 5V FUEL INJECTION AND IGNITION, ENGINE CODE(S): BHF
- After reconnecting voltage supply, ABS Malfunction Indicator Lamp (MIL) only goes out after driving several meters.
Tightening torque
| Component | Nm |
| Battery terminal to battery post | 6 |