Rear seat child seat anchorage (Sedan)
Special tools, testers and auxiliary items required
- Torque wrench V.A.G 1331
NOTE:
- Mounts for 3 child seat anchorages can be installed.
- Remove rear shelf → Rear shelf, removing and installing .
1 - Pop rivet
- Qty. 3 per plate
- For securing threaded washer - 2 - to plate
NOTE:
- The threaded plate must always be installed from below (luggage compartment side)
2 - Threaded plate
- Threaded insert points upward
3 - Cover cap
- To install, position rear and press front down (symbol faces toward front).
4 - Screw
- Tightening torque 23 Nm
5 - Anchorage
6 - Spacer sleeve