Ignition/starter switch, removing and installing

Removing

Remove Steering Column Switch Module (SCSM). Refer to Steering Column Switch Module (SCSM), removing and installing .
Check whether the electrical harness connector at induction coil is disconnected.

Fig 1: Locating Screws , Ignition/Starter Switch And Steering Lock Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect harness connector -1- at ignition/starter switch.
Remove sealing paint from both mounting screws -arrows-.
Loosen mounting bolts -arrows- somewhat and pull ignition/starter switch out of steering lock housing -2-.

Installing

Installation is reverse of removal, paying attention to the following:

NOTE: Make sure ignition/starter switch and lock cylinder are both in the same position, for example "ignition on" when installing.

Fig 2: Locating Screws , Ignition/Starter Switch And Steering Lock Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.