Headlight beam adjusting motors, removing and installing
Removing
- Remove headlight. Refer to Headlights, removing and installing: .
- Remove housing cover from headlight housing.
- Remove bolts -arrows-.
- Push out ball head of adjustment axle by swinging adjusting motor -2- to the side out of ball head mount.
- Disconnect electrical harness connector -1-.
Installing
Installation is reverse of removal, paying attention to the following:
- Install headlight. Refer to Installing .
NOTE:
Always adjust headlights after adjusting motors are removed and installed or are replaced. Refer to
Headlights, adjusting .
Tightening torque
| Component | Nm |
| Adjusting motor for vertical headlight beam control to headlight housing | 1.2 |