Light bulb for low beam, replacing

Removing 

• Remove headlight. Refer to Headlights, removing and installing: .
• Remove housing cover from headlight housing.

Fig 1: Identifying Harness Connector At Low Beam Bulb, Wire Clamp, And Bulb

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect harness connector -1- at low beam bulb.
• Disengage wire clamp -2- and remove bulb -3- from housing.

Installing 

Installation is reverse of removal, paying attention to the following:

• Insert new bulb into housing, do not touch glass portion with bare hands.
• Secure bulb using wire clamp.
• Reconnect harness connector and close housing cover.
• Secure housing cover using wire clamp.