Headlights, removing and installing:: Removing

• Switch ignition off and remove ignition key.
• Turn light switch into -0- position.

Left headlight: 

• Remove cover -1- in engine compartment (left side).

Right headlight: 

• Remove cover -1- in engine compartment (right side), if present.

• Remove bolts -arrows-.
• Detach Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80- -1- at air guide.
• Remove air duct -2-.

Continuation for both sides: 

• Apply adhesive tape below the headlight to protect the paint.

• Remove bolts -1- and -4-.
• Loosen screw -2- several turns but do not remove completely.
• Cut cable tie if present.
• Disconnect electrical harness connector -3-.

• Swing headlight in direction of fender.
• Remove headlight from body toward front.