Wiring harness for backrest, removing and installing
Special tools, testers and auxiliary items required
- Engine and transmission holder VAS 6095
- Fixture for seat repair VAS 6136
1 - Connector (3x)
2 - Cable harness
- Removal:
- Remove seat → Front power seats with memory, removing and installing .
- Mount the fixture for seat repair VAS 6136 on the engine and transmission holder VAS 6095.
- Attach the front seat to the fixture for seat repair VAS 6136.
- Remove side trim on sill side → Side panels on door sill side, removing and installing .
- Remove side trim on tunnel side → Side panels on door sill side, removing and installing .
- Remove the backrest → Front backrest, removing and installing .
- Remove backrest cover panel → Backrest cover, removing and installing .
- Remove cover and padding from backrest → Backrest cover and padding, removing and installing .
- Remove cable ties - 3 - (3x).
- Remove connectors - 1 - (3x).
- Remove wiring harness - 2 -.
- Installing:
Installation is reverse of removal.
3 - Cable ties (3x)