Lock cylinder, removing and installing: Installing

WARNING: This page is about a different car, the 2004 Audi S4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

Insert spare key into lock cylinder and turn to position "ignition on".

Re-insert steel wire or pin -1- into the hole in front of lock up to stop.

Fig 1: Re-Inserting Steel Wire Or Pin Into Hole In Front Of Lock Up To Stop

Courtesy of AUDI OF AMERICA, INC.

Slide lock cylinder -2- with induction coil into steering lock housing -3-.
Then pull out wire and press in lock cylinder firmly until catch engages audibly.
Install steering column switch:
See STEERING COLUMN SWITCH MODULE (SCSM), REMOVING AND INSTALLING .
Connect electrical harness connector at induction coil for anti-theft immobilizer when installing steering column switch.