Fuel Level Sensor G , removing and installing: Installing

Installation is in reverse order of removal. Note the following:

Fig 1: Placing Fuel Level Sensor G Into Guide In Outer Part Of Baffle Housing And Pressing It Downward

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Place fuel level sensor G into guide in outer part of baffle housing and press it downward - arrow  - until it is audibly engaged.

Fig 2: Separating Electrical Connection On Inner Side Of Locking Flange

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Connect electrical connection - arrow  - on inner side of locking flange.
• Install new locking flange seal dry.
• Bring locking flange to installation position.

Fig 3: Identifying Tab On Locking Flange Lies Between Tabs On Fuel Tank

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Tab - 2  - on locking flange must lie between tabs - 1  - and - 3  - on fuel tank.

Fig 4: Removing/Installing Locking Ring With Wrench T10202

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Tighten locking ring.
• Connect battery. Observe safety precautions after connecting battery →
  • 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
  • 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
  .