Leak Detection Pump (LDP) V144 , removing and installing
Removing
NOTE:
- All cable ties which are opened or cut open when removing, must be replaced in the same position when installing.
- Remove left rear wheel.
- Remove left rear wheel housing liner →
- 66 EXTERIOR EQUIPMENT
- 66 - EXTERIOR EQUIPMENT for BODY EXTERIOR - CABRIOLET
- Remove nuts - arrows -.
- Detach leak detection pump with bracket.
- Disconnect electrical connector - 3 - with ignition switched off.
- Disconnect hose coupling - 4 - by pressing release button.
- Cut cable ties - 1 - and disconnect the hose - 2 -.
Installing
Installation is in reverse order of removal. Note the following:
NOTE:
- Secure all hose connections using hose clamps appropriate for the model type .
- During installation, the cable ties must be re-installed at the same location.
- Secure hose - 2 - to bracket of leak detection pump with cable tie - 1 -.
Torque specifications
| Component | Nm | |
|---|---|---|
| Bracket for leak detection pump to wheel housing | 4 | |