Check activation

Fig 1: Diagnostic System VAS 5051: Display

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS 5051 :

In selection - 1 - , click on diagnostic function "03 - Output Diagnostic Test Mode (DTM)".

Fig 2: Display On VAS 5051 - (1st Control Element In Test & Evaporative Emission (EVAP) Canister Purge Regulator Valve-N80-)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Display on VAS 5051 :

A - Output diagnostic test mode waiting, advancing by switching required

1 - Evaporative Emission (EVAP) Canister Purge Regulator Valve N80

Press → button repeatedly until leak detection pump for fuel system is activated

NOTE:

Operating noise of Leak Detection Pump (LDP) is audible at left rear wheelhousing.

If Leak Detection Pump (LDP) for fuel system is not activated (no operating noise audible):

Remove leak detection pump (LDP) V144 → Leak Detection Pump (LDP) V144 , removing and installing and disconnect the electrical connection.

Fig 3: Locating 3-Pin Connector At Fuel System Leak Detection Pump V144

Courtesy of VOLKSWAGEN UNITED STATES, INC.