Hose routing, EVAP canister/leak detection system 6-cyl. (MPI-engine)

1 - Throttle valve control module J338

2 - Evaporative Emission (EVAP) Canister Purge Solenoid Valve N80

• Location: Right front in engine compartment

3 - Ventilation line

• From EVAP canister to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
• Installed location: At right beneath vehicle floor
• Secured to fuel tank in fuel tank area

4 - Ventilation line

• To gravity valve at fuel tank

5 - EVAP canister

• Location: Bottom of spare wheel well
• Removing and installing → Evaporative emissions (EVAP) canister, removing and installing 

6 - Connecting hose

• Leak detection pump/EVAP canister
• Pressure side

7 - Air filter housing

• For leak detection pump (LDP) V144

8 - Leak detection pump (LDP) V144

• Location: In left rear wheel housing behind wheel housing liner
• Check using "Guided Fault Finding"
• Checking → Leak Detection Pump (LDP) V144 , checking (vehicles with MPI-engine) 
• Removing and installing → Leak Detection Pump (LDP) V144 , removing and installing 

9 - Vacuum line

• To leak detection pump (LDP) V144