Version 1
1 - Side curtain airbag connector
2 - Side curtain airbag
- Removal:
- Disconnect the battery ground (GND) strap →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
- Remove sun visor → Sun visor, removing and installing .
- Remove upper trim on A-pillar → Upper A-pillar trim, removing and installing .
- Remove D-pillar trim → D-pillar trim, removing and installing .
- Remove trim above rear door → Trim above rear door, removing and installing .
- To disconnect harness connector - 1 -, open fuse using a screwdriver.
- Remove screw - 6 -.
- Loosen four bolts - 7 -.
- Remove screw - 5 -.
- Place front part of side curtain airbag module on seats.
- Loosen three bolts - 3 -.
- Remove four bolts - 4 - and remove brackets - arrows - from roof frame.
- Remove head-level airbag - 2 - from vehicle.
- Installing:
CAUTION:
Always follow side curtain airbag installation procedure.
- Insert brackets - arrows -.
- Secure four brackets -arrows- beginning from behind with four bolts - 4 -.
- Install three bolts - 3 -.
- Install last bolt - 5 -.
- Install four bolts - 7 -.
- Install bolt - 6 -.
- When connecting harness connector - 1 -, make sure that it is firmly engaged.
Further installation is performed in the reverse order of removal. Observe the following when doing so:
- Switch on ignition.
CAUTION:
No one should be in vehicle when connecting battery.
- Connect the battery ground (GND) strap →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
NOTE:
- Follow safety measures after connecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 - BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT - GENERAL INFORMATION
- If the Airbag Malfunction Indicator Lamp (MIL) K75 shows a malfunction after assembly, DTC memory must be checked with Vehicle Diagnostic, Testing and Information System VAS 5051 A, cleared and then rechecked.
3 - Bolts (3x)
- Tightening torque 3.5 Nm
- Self-locking
- Replace after each disassembly
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
4 - Screws (4x)
- Tightening torque 3.5 Nm
- Self-locking
- Replace after each disassembly
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
5 - Screw
- Tightening torque 3.5 Nm
- Self-locking
- Replace after each disassembly
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
6 - Screw
- Tightening torque 3.5 Nm
- Self-locking
- Replace after each disassembly
- Threaded holes for screws must always be cleaned (for example, with thread cutter)
7 - Screws (4x)
- Tightening torque 3.5 Nm
- Self-locking
- Replace after each disassembly
- Threaded holes for screws must always be cleaned (for example, with thread cutter)