Cover and cushion for seat pan, removing and installing (sport seat): Notes

1 - Cover

• Removal:

• Remove seat: Vehicles until 10.04 → Front seats (standard seat), removing and installing , vehicles from 11.04 → Front seats (standard seat), removing and installing .
• Remove backrest: Vehicles until 10.04 → Front backrest (standard seat), removing and installing , vehicles from 11.04 → Front backrest (standard seat), removing and installing .
• Unclip connector for heated seat - 2  - from bracket.
• Pry out plastic strips - 3  - all around using a screwdriver.

• For vehicles with LATCH "Lower Anchor and Tethers for Children" bracket and new cover - 1  -, cover must be cut in at LATCH "Lower Anchor and Tethers for Children" bracket.

2 - Seat heating connector

3 - Circular plastic strips

4 - Fastening strips

5 - Plastic clips

• Replace damaged plastic clips

6 - Upholstery

7 - Seat heating

8 - Seat pan

1 - Seat cushion extension

• Removal:

• Remove nuts - 2  - (4x).
• Remove cover and upholstery.

• Installing: 

Installation is reverse of removal. Observe the following when doing so:

• Damaged plastic clamps must be replaced.

2 - Nuts (4x)