Disconnecting connections

1 - Front seat

2 - Belt buckle sensor connector (black)

3 - Seat heater connector (green)

4 - Current supply connector (red)

5 - Airbag connector (yellow)

6 - Connector point cover

• Removal:

• Tip front seat - 1  - back.
• Remove coupling station cover - 6  - upward.
• Press in tab on airbag connector - 5  - on tunnel side and disconnect airbag connector - 5  -.
• Press in tab on connector for voltage supply - 4  - on tunnel side and disconnect connector for voltage supply - 4  -.

• Press in tab on connector for heated seat - 3  - on tunnel side and disconnect connector for heated seat - 3  -.

Vehicles with seatbelt fasten sensor: 

• Press in tab on connector for seatbelt fasten sensor - 2  - on tunnel side and disconnect connector for seatbelt fasten sensor - 2  -.

All: 

• Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
• Remove front seat - 1  -.

• Installing: 

Installation is reverse of removal.