Mirror adjuster switch, removing and installing

Removing 

• Remove front door trim:

Refer to 70 - INTERIOR TRIM

Fig 1: Identifying Bolts At Pull Handle For Closing On Back Side Of Door Trim

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove bolts -arrows- at pull handle for closing on back side of door trim.
• Remove panel for pull handle for closing on front side, under mirror adjuster switch.

Fig 2: Identifying Connector At Mirror Adjuster Switch, And Catches

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect connector -1- at mirror adjuster switch -2-.
• Carefully release catches -arrows- using a small screwdriver.
• Pull mirror adjuster switch downward out from pull handle for closing.

Installing 

Installation is reverse of removal, paying attention to the following:

• Press mirror adjuster switch into switch mount until catches engage.